Share
Pin
Tweet
Send
Share
Send
Detailed electronic diagram of the operation of the rear fog lights and front high / low beam headlights of the Audi 100.
Almost every car owner of an Audi 100 is faced with the work of headlights and rear foglights, and you will need a diagram to repair this electronic equipment. At the end of the work, put it back. All schematic symbols are described here.
Diagram of headlights and rear fog lamps:
T2c - 2-pin connector (black) located on the left in the engine compartment; | E7 - Audi 100 fog lamp switch; |
T2d - 2-pin connector (black) located on the right in the engine compartment; | E18 - rear fog lamp switch; |
T6k - 6-pin connector (black) located behind the dashboard; | L20 - rear fog lamp lamp; |
T10a - 10-pin connector (brown) located behind the dashboard; | L22 - connection of the left fog lamp; |
T10b - 10-pin connector (brown) located behind the dashboard; | L23 - connection of the right fog lamp; |
T10s - 10-pin connector (black) located behind the dashboard; | 81 - connection with "mass" 1 in the wiring harness of the Audi 100 instrument panel; |
S1 - fuse on the relay board; | 82 - connection to "mass" 1 in the front wiring harness on the left; |
A20 - connection (15a) in the wiring harness of the instrument panel. | 87 - connection to "mass" 1 in the rear wiring harness; |
Audi
Share
Pin
Tweet
Send
Share
Send